Milty Polipods (8pk)
Polipods are high performance vibration absorbing supports designed to be placed under CD Players, Turntables, Amplifiers, Loudspeakers and all other Audio, Video & Computer equipment. Each Polipod is accurately replicated from a precisely machined and polished master in order to provide equal dimensional and volumetric support.
Other products to consider

Milty Zerostat 3
View

Milty Permaclean
View

Milty Foculpods (4pk)
View
How to replace your cartridge and set up your turntable
Step 1
Put the cartridge up to the headshell and gently tighten the screws into the holes.
Step 2
Then use the Allen key to tighten (but not over-tighten) the cartridge into place. To
prevent damage, be careful not to knock the stylus guard or stylus
Step 3
Then connect the wires from the back of the tone arm to the coloured connecting pins at the
rear of the cartridge. Each wire is colour coded (red, white, green, blue). It is best
to use tweezers or a pair of small pliers to connect them.
Step 4
As they are very delicate, it is best to grab the wire by the connector to prevent damage.
Ensure the wires are connected properly.
Step 5
The next stage is correctly aligning the cartridge to the protractor. Gently put the stylus
of the cartridge on to the crossover point of the protractor.
Step 6
Holding the cartridge off the protractor, use the Allen key to gently loosen the screws. Once loosened
you need to rotate the cartridge so that it is parallel with the lines on the protractor. When you are
happy that they are parallel, you need to re-tighten the screws.
Step 7
When tightened, place the stylus back on the protractor to confirm it still lines up.
Step 8
Use the second chart to check that everything is parallel in both positions. When you are
happy, ensure the screws are tight enough (but not too tight). Your cartridge is now
correctly aligned.