Show the menu Goldring website
Close
Cartridges
Turntables
Record Care
Cartridge repair
Where to buy
About Goldring

Milty Zerostat 3

Effective at neutralising static charges on virtually any surface without the need of sprays. The Zerostat 3 is highly rated for its ability to improve the sound quality of records and CDs by removing static. The Zerostat 3 incorporates a unique Piezo Crystal device which generates a positive electrical charge of ions with one gentle squeeze of the trigger, and a negative charge on release of the trigger so cancelling the charges on the disc. Constructed from durable hard plastic, it requires no batteries or refills and is a long lasting alternative to cleaning brushes.


Other products to consider


Milty Super Exstatic Disc Cleaner

Milty Record Brush

Milty Permaclean

Milty Exstatic Record Sleeves

How to replace your cartridge and set up your turntable




Step 1
Put the cartridge up to the headshell and gently tighten the screws into the holes.

Step 2
Then use the Allen key to tighten (but not over-tighten) the cartridge into place. To prevent damage, be careful not to knock the stylus guard or stylus

Step 3
Then connect the wires from the back of the tone arm to the coloured connecting pins at the rear of the cartridge. Each wire is colour coded (red, white, green, blue). It is best to use tweezers or a pair of small pliers to connect them.

Step 4
As they are very delicate, it is best to grab the wire by the connector to prevent damage. Ensure the wires are connected properly.

Step 5
The next stage is correctly aligning the cartridge to the protractor. Gently put the stylus of the cartridge on to the crossover point of the protractor.

Step 6
Holding the cartridge off the protractor, use the Allen key to gently loosen the screws. Once loosened you need to rotate the cartridge so that it is parallel with the lines on the protractor. When you are happy that they are parallel, you need to re-tighten the screws.

Step 7
When tightened, place the stylus back on the protractor to confirm it still lines up.

Step 8
Use the second chart to check that everything is parallel in both positions. When you are happy, ensure the screws are tight enough (but not too tight). Your cartridge is now correctly aligned.