Goldring 2300 Cartridge
All Goldring 2000 series cartridges feature Moving Iron technology. This lends them the high levels of detail associated with more expensive moving coil designs whilst retaining the convenience of a replaceable stylus and high output associated with moving magnet types. The cartridge employs a fixed samarium cobolt magnet and high output coil combination so that a very light iron/nickel cantilever end-piece can be used instead of the much heavier permanent magnet used in conventional designs. This reduces the moving mass of the cartridge allowing the stylus to trace the record groove more faithfully. Because of their high output, Goldring 2000 series cartridges should be used with the standard moving magnet phono input of an integrated amplifier.
Use of a nude elliptical diamond offers high clarity and excellent tracking ability. This record cartridge will upgrade many mid-range turntables, allowing them to produce an even finer sound.
|Frequency Response ||20 Hz - 20kHz +/- 3 dB|
|Channel Balance|| within 2 dB @ 1 kHz|
|Channel Separation||better than 20 dB @ 1 kHz|
|Sensitivity||6.5 mV 1.5 dB, 1 kHz @ 5 cm/sec|
|Static Compliance||35 mm/N|
|Dynamic Compliance @ 10 Hz||16 mm/N|
|Vertical Tracking Angle||24|
|Stylus Radius||Nude Elliptical|
|Load Resistance||47 k|
|Load Capacitance||100 - 200 pF|
|Internal Inductance||680 mH|
|Internal Resistance||550 |
|Cartridge Mass||7.4 g|
|Cartridge Mass ( inc. fixing screws)||8.6 g|
|Fixing Centre||0.5" (12.7 mm)|
|Playing Weight||1.5 - 2.0 g (1.7 g nom.)|
Other products to consider
Goldring 2200 Cartridge
Goldring 2400 Cartridge
Goldring 2500 Cartridge
Goldring 2100 Cartridge
How to replace your cartridge and set up your turntable
Put the cartridge up to the headshell and gently tighten the screws into the holes.
Then use the Allen key to tighten (but not over-tighten) the cartridge into place. To
prevent damage, be careful not to knock the stylus guard or stylus
Then connect the wires from the back of the tone arm to the coloured connecting pins at the
rear of the cartridge. Each wire is colour coded (red, white, green, blue). It is best
to use tweezers or a pair of small pliers to connect them.
As they are very delicate, it is best to grab the wire by the connector to prevent damage.
Ensure the wires are connected properly.
The next stage is correctly aligning the cartridge to the protractor. Gently put the stylus
of the cartridge on to the crossover point of the protractor.
Holding the cartridge off the protractor, use the Allen key to gently loosen the screws. Once loosened
you need to rotate the cartridge so that it is parallel with the lines on the protractor. When you are
happy that they are parallel, you need to re-tighten the screws.
When tightened, place the stylus back on the protractor to confirm it still lines up.
Use the second chart to check that everything is parallel in both positions. When you are
happy, ensure the screws are tight enough (but not too tight). Your cartridge is now